Bulletin 30-122.2014.04.006 7 Copyright © 2014 Unico, Inc.
(SAC xx.xxxx.xxx.xx)
Prepare the terminals of the wire to connect to the
terminal strip, connect them and secure the wiring
with clamp provided. (See wiring diagrams).
Loose wiring may cause the terminal to overheat or result
in unit malfunction. A fire hazard may also exist. Therefore,
be sure all wiring is tightly connected.
Install the condensate drain to the outside with a
positive slope. The condensate can then be carried
away in a channel or collected into a reservoir so that it will
evaporate. A trap may be installed in the condensate line to
prevent air movement in the line.
Remove the front panel.
Fill the tube and verify that the condensate can flow
correctly. Reassemble the grille according to “L”.
To Next Page
Loading...
Need help?
General
