Why unicraft EKZT 301-1 motor is not functioning?
The motor of your Unicraft Chain Hoist might not be working due to several reasons: there could be an inadequate power supply (check the power supply), a wrong phase conductor (change the phase), a defective switch (replace the switch), a defective rectifier (replace the rectifier), a defective transformer (replace the transformer), or the motor itself could be defective (replace the motor).
What to do if unicraft Chain Hoists runs on too long after switch-off?
If your Unicraft Chain Hoist continues to run for too long after being switched off, the issue could be due to several factors. It might be caused by an oily brake disc (clean the brake disc), a worn brake disc (replace the brake disc), a defective compression spring (replace the compression spring), or an overload (reduce the load).
Why unicraft EKZT 301-1 Chain Hoists has leakage current?
Leakage current in your Unicraft Chain Hoists can occur due to several reasons: poor or no earthing (check earthing and/or restore connection), interior cables in contact with the casing (check wiring), high humidity (avoid operation in a very humid atmosphere), or dirty live components (keep equipment clean).
Why unicraft EKZT 301-1 Chain Hoists motor restarts after function key is released?
If the motor of your Unicraft Chain Hoist restarts after releasing the function key, the switch is likely defective and should be replaced.
What to do if unicraft EKZT 301-1 has unusual noises?
Unusual noises in your Unicraft Chain Hoist may be due to a chain that is dry or very worn (lubricate or replace the chain) or gear wheels that are very worn (replace the gear wheels).
Why unicraft EKZT 301-1 Chain Hoists temperature of motor too high?
If the motor temperature of your Unicraft Chain Hoist is too high, it is likely due to an excessive workload. Reduce the load to resolve this issue.
How to fix upper and lower limit switches not functioning in unicraft Chain Hoists?
If the upper and lower limit switches on your Unicraft Chain Hoist are not functioning, it could be due to a poor connection (check the connection) or a defective limit switch (replace the limit switch).
General| Brand | unicraft |
|---|---|
| Model | EKZT 301-1 |
| Category | Chain Hoists |
| Language | English |
To Next Page
