Name: unicraft EKZT Series
Brand: unicraft
Rating: 4 (1 reviews)

Questions and Answers:

matthewhoustonAug 8, 2025

Why is my unicraft EKZT motor not working?

B
Bethany HawkinsAug 8, 2025
If the motor of your Unicraft Chain Hoists isn't working, there are several potential causes. It could be due to an inadequate power supply, so you should check the power supply first. Other possible causes include a wrong phase conductor (change the phase), a defective switch (replace the switch), a defective rectifier (replace the rectifier), a defective transformer (replace the transformer), or a defective motor (change the motor).

Rebecca SnyderAug 12, 2025

What to do if unicraft EKZT Chain Hoists runs on too long after switch-off?

C
Cynthia JarvisAug 12, 2025
If your Unicraft Chain Hoists continues to run for too long after being switched off, there are several possible reasons: * The brake disc might be oily; if so, clean the brake disc. * The brake disc could be worn, requiring you to replace it. * The compression spring might be defective; if this is the case, replace the compression spring. * There might be an overload, so reduce the load.

Protection Class

IP54

Lifting capacity

250 - 5000 kg

Number of chain falls

1 or 2

Lifting Height

3 m to 30 m

Chain Falls

1 or 2

Power Supply

400V / 50Hz / 3Ph

Ambient Temperature

+40°C

unicraft EKZT Series User Manual

Questions and Answers: