Uniden FP1100 - User Manual

FP1100
Corded Telephone
Owner’s Manual
Visit the our website at:
www.uniden.com.au
for Australian model or
www.uniden.co.nz
for New Zealand model
(c) 2009 Uniden Australia Pty Limited/
Uniden New Zealand Limited
Printed in PRC
Important Safety Information
Introduction
Your telephone is designed to give you exibility
in use and high quality performance. To get the
most from your new telephone, we suggest
that you take a few minutes right now to read
through this instruction manual.
CAUTION: When using telephone
equipment, there are basic safety
instructions that should always be
followed. Refer to the IMPORTANT
SAFETY INFORMATION provided
with this product and save them for
future reference.
NOTE: This phone uses Touch-Tone
dialing service only. For this telephone
to function properly, you must use
Touch-Tone service available through
your local telephone company.
Hearing Aid Compatibility (HAC).
Before You Begin
Important Installation
Information
•Neverinstalltelephonewiringduringa
lightning storm.
•Neverinstalltelephonejacksinwet
locationsunlessthejackisspecically
designed for wet locations.
•Nevertouchnon-insulatedtelephone
wires or terminals, unless the telephone
line has been disconnected at the network
interface.
•Usecautionwheninstallingormodifying
telephone lines.
•Temporarilydisconnectanyequipment
connected to the phone such as faxes,
other phones, or modems.
Handset Layout
Redial
Button
RINGER
Volume
Switch
Flash
Button
Earpiece
Volume
Switch
Installing the Phone
Your telephone should be placed on a level
surface such as a desk or table top, or you can
mount it on a wall. A desktop/wall mounting
pedestal is built into the base of the phone.
1.SlidetheRINGERvolumeswitch(onthe
handset) to the desired volume.
2. Set the earpiece volume switch (on the
handset) to the desired listening volume.
3. Plug the telephone line cord into a modular
wallphonejack.
4. Store the extra cord in the grooves in the
base.
Wall Mount Installation
Your telephone may also be mounted on a wall
plate (not included).
NOTE: To prevent the handset from
falling out of the cradle while the
phone is hanging on the wall, you
must reverse the handset hook
(located on the base).
1. Push the handset hook up and out of the slot
on the base with your thumb, rotate the hook
180°, and replace it back in the slot.
2. Plug the telephone line cord into a modular
wallphonejack.
3. Slip the mounting holes on the base over
thewallplatepostsandrmlyslidetheunit
down into place (wall plate not included).
WARNING: TO
PREVENT FIRE
OR ELECTRICAL
SHOCK HAZARD,
DO NOT EXPOSE
THIS PRODUCT
TO RAIN OR
MOISTURE.
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:

Summary

Important Safety Information

Introduction

Before You Begin

Important Installation Information

Crucial safety and location guidelines for installing telephone wiring and jacks.

Handset and Phone Layout

Installing the Phone

Instructions for desktop or wall mounting the telephone base and handset.

Wall Mount Installation

Specific steps to secure the phone to a wall plate.

Telephone Operation

Redial Function

How to redial the last number called.

Flash - Call Waiting

Using the flash button for call waiting service.

Earpiece Volume Control

Adjusting the listening volume on the handset.

Ringer Volume Control

Adjusting the volume level of incoming calls.

Troubleshooting Tips

No Dial Tone Issues

Steps to resolve the absence of a dial tone.

Phone Not Ringing

How to fix the issue where the phone does not ring.

Audio Issues

Troubleshooting when the other party cannot hear you.

General Product Care

One-Year Limited Warranty

Warranty Coverage and Limitations

Details on warranty validity, covered parts, and remedies.

Procedure for Obtaining Warranty

Instructions on how to contact the warrantor for service.

Uniden FP1100 Specifications

General

Type	Cordless Phone
Number of Handsets	1
Caller ID	Yes
Phonebook Capacity	50
Battery Type	Ni-MH
Talk Time	10 hours
Standby Time	5 days
Call Waiting	Yes
Redial	Yes
Ringer Volume	Adjustable
Handset Volume	Adjustable
Power Source	AC Adapter
Display	LCD