What to do if Uniphos FumiSense Pro UNIPHOS-250 PM instrument does not turn on?
If your Uniphos Gas Detectors instrument doesn't turn on, the most likely cause is a low battery. The solution is to recharge the battery.
Why is my Uniphos FumiSense Pro UNIPHOS-250 PM Gas Detectors pump making abnormal noise?
If the pump in your Uniphos Gas Detectors is making an abnormal noise, it could be due to a blockage in the gas sampling tube or nozzles. Clear any blockage to resolve this issue.
Explains the electrochemical sensor technology used for Phosphine detection.
Details the two-step calibration process: zeroing and span calibration.
Step-by-step guide for zeroing and span calibration of the instrument.
Explains how to select sampling type and enter sampling mode.
Instructions for entering data download mode and selecting reports.
General| Resolution | 0.1 ppm |
|---|---|
| Sensor Type | Electrochemical |
| Display | LCD |
| Detection Gas | Phosphine (PH3) |
| Target Gas | Phosphine |
| Alarm | Audible, Visual |
| Battery | Rechargeable Lithium-ion |
| Accuracy | ±5% of reading |
| Operating Temperature | -20°C to +50°C |
| Power Supply | Rechargeable Lithium-ion battery |
| Connectivity | USB for charging |
| Operating Humidity | 15-95% RH (non-condensing) |
To Next Page