Unique UGP-20V PC1 S/S

Questions and Answers

C
Cynthia SchneiderAug 14, 2025
Why won't the surface burners light on my Unique range?
- C
  carrie24Aug 14, 2025
  If the surface burners on your Unique range aren't lighting, here's what to check: * Ensure the surface control is fully turned to the 'ON' position. Push it in and turn until the burner ignites, then adjust to your desired flame. * Inspect burner ports for clogs. Use a small gauge wire or needle to clear any obstructions. * Confirm burners are correctly positioned on the orifice hoods and sitting flat on the burner support, with tabs engaged in slots. * Make sure the range power cord is plugged into a grounded outlet. * If it is a power failure, light burners manually.
A
acummingsAug 18, 2025
What to do if my Unique range oven or broiler does not heat?
- D
  Danielle DuncanAug 18, 2025
  If your Unique range's oven or broiler isn't heating, consider the following: * Ensure the temperature control is set to the desired temperature. * Check if a house fuse has blown or a circuit breaker has tripped. Reset the breaker or replace the fuse, without increasing its capacity. If overloading is the issue, consult a qualified electrician. * Be sure the range cord is plugged into a grounded outlet. * In case of a power failure, light the burners manually.
T
Tristan MendezAug 21, 2025
How to fix inaccurate oven temperature in my Unique range?
- M
  Mark LongAug 21, 2025
  If you're finding that the oven temperature in your Unique range is inaccurate, try these steps: * Check the oven capillary bulb to ensure it is correctly positioned, snapped in the clips straight and not touching the sides, and free from oven cleaner or food. * Verify that the temperature control knob is set to the desired temperature. * Ensure proper use of foil, keeping it clear of holes in the oven bottom and away from the oven sides. * Make sure the vent on the backguard is clear.
A
Amy PierceAug 25, 2025
Why does the flame burn half-way round on my Unique range?
- M
  Matthew PearsonAug 25, 2025
  If the flame on your Unique range burner only burns halfway around, here's what you can do: * Check for clogged burner ports and use a small gauge wire or needle to open them. * If moisture is present after cleaning, lightly fan the flame and allow the burner to operate until the flame is full. Alternatively, thoroughly dry the burners following the cleaning instructions.
K
Kathleen HartAug 28, 2025
How to level my Unique range?
- M
  michaelnelsonAug 28, 2025
  If your Unique range isn't level, here are some things to consider: * Ensure proper installation by placing an oven rack in the center of the oven, putting a level on the rack, and adjusting the leveling legs. * Check if the floor is level and can adequately support the range. If the floor is sagging or sloping, contact a carpenter. * Kitchen cabinet misalignment may make the range appear unlevel. Ensure cabinets are square and have sufficient room for range clearance. Contact a cabinet maker to correct the problem.
S
sthomasSep 1, 2025
Why is the flame orange on my Unique range?
- J
  Jennifer WelchSep 2, 2025
  If the flame on your Unique range is orange, allow the burner to operate for a few minutes until the flame turns blue. This can happen due to dust particles in the main line.
S
Sarah BowmanSep 5, 2025
What to do if my Unique range oven smokes excessively?
- M
  Maria MaddenSep 5, 2025
  If your Unique range oven smokes excessively, reposition the broiler pan to provide more clearance between the meat and the broiler burner or remove excess fat from the meat.
J
Jimmy JohnsonSep 8, 2025
How to fix the oven light on my Unique range?
- J
  James JenningsSep 9, 2025
  If the oven light in your Unique range isn't working, try tightening or replacing the oven light bulb.