UNIS CUBE II - 3.3 Connection to the electric power; 3.4 Before first turn-on

OPERATING MANUAL FOR CUBE II
6
e) Insert the rear cover strip and replace the top glass back.
f) Push the rail back (to the right).
3.3 | Connection to the electric power
The case is designed for single-phase voltage 230V / 50 Hz. The power supply socket must be separately grounded and
protected by a fuse of 10A or 16A. Other devices must not be attached to this separately fused circuit.
3.4 | Before first turn-on
1) Clean the exhibition space and shelves with a slightly damp cloth and a suitable detergent.
2) Dry the surface of washed surfaces with a dry cloth.
3) Chill the interior properly, see chapter 5.2 Turn on.