UNIS CUBE II - OPERATION; 3.1 Place of operation; 3.2 Assembling

OPERATING MANUAL FOR CUBE II
5
3|OPERATION
3.1 | Place of operation
1) The showcase will work correctly:
- At the workplace with temperature from +16°C to +25 °C
- With ambient humidity max. to 60% RH
2) Do not operate the showcase:
- near the heating sources
- in the place where sunlight can affect operation of the unit
- in the place with draught (from air-conditioner or near the entry)
- near other objects which could prevent proper ventilation
3.2 | Assembling
1) Showcase should be align to the horizontal position by using the adjustable feets on the bottom of the display case.
Align the showcase by turning the adjustable feet with wrench nr. 24 into horizontal position. After the
establishment, secure the position of the feets by tightening the nut wrench nr. 17.
2) Insert consoles in the brackets.
3) Insert glass shelves.
4) Hang back doors:
a) Slide the upper glass slightly forward.
b) Press the clips on the lower left side of back cover strip and slide it
to the left.
c) While the angle is about 45 ° fit the inner rear door.
d) While the angle is about 45 ° fit the outer rear door.