HT510 User’s Manual
1.4.4 Using Cradle
One slot terminal charging cradle with battery charger
￭ Provide 5VDC power for operating the HT510
￭ Simultaneously charges up to one HT510 terminal and one battery using the
standard cradle.
1.4.5 Factory Reset
To get in a recovery mode to launch the factory reset, please follow the
instructions below.
1. Power off the device.
2. Hold "Power button" + "Left Scan key."
3. In Select Boot Mode menu, use Left Scan Key to select Recovery and
Right Scan Key to enter the selection.
4. In recovery menu, use arrow key up and down to move the cursor.
Power key to enter selection.
9 © 2019 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
All product and company names are trademarks, service marks, or registered trademarks of their respective owners
To Next Page
Loading...
Need help?
General
