Unitech KP3800 - Codabar; Upc-A

24 Keyboard Manual
Bar Code Symbologies, continued
UPC-A
Send Check Digit toggles whether or not to send a check digit.
Default is “Send”.
•
Send Leading Digit toggles sending or not sending a leading
(“start bar code”) digit. Default is “Send”.
•
Code ID is a user-definable identification letter for UPC-A, which
is referred to in the “Use Code ID” function (see page 11).
Default is letter “A”.
•
Enabled toggles the ability for the keyboard/scanner to read
UPC-A on or off. Default is “Yes”.
•
Codabar
Maximum Length defines the maximum length the user will
accept for a valid bar code. Default is “48”.
•
Minimum Length defines the minimum length the user will
accept for a valid bar code. Default is “3”.
•
CLSI Format deletes the start and stop sentinels and outputs the
data with spaces inserted after the 1st, 5th, and 10th characters.
Default is “No”.
•
Check Digit defines whether or not a check digit (to insure data
accuracy) is calculated, and if so, whether it should be sent or
not. Default is “Not Calculate”.
•
Send Start/Stop toggles sending or not sending start/stop
sentinels. Default is “No Send”.
•
Code ID is a user-definable identification letter for Codabar,
which is referred to in the “Use Code ID” function (see page 11).
Default is letter “N”.
•
Enabled toggles the ability for the keyboard/scanner to read
Codabar on or off. Default is “No”.
•