Unitech KP3800 - Upc-E; Ean-13; Ean-8

25Keyboard Manual
EAN-8
Send Check Digit toggles whether or not to send a check digit.
Default is “Send”.
•
Send Leading Digit toggles sending or not sending a leading
(“start bar code”) digit. Default is “Send”.
•
Code ID is a user-definable identification letter for EAN-8, which
is referred to in the “Use Code ID” function (see page 11).
Default is letters “FF”.
•
Enabled toggles the ability for the keyboard/scanner to read
EAN-8 on or off. Default is “Yes”.
•
Bar Code Symbologies, continued
EAN-13
Bookland EAN toggles whether or not to send the EAN-13 bar
code data in Bookland EAN (ISBN) format. Default is “No”.
•
Send Check Digit toggles whether or not to send a check digit.
Default is “Send”.
•
Send Leading Digit toggles sending or not sending a leading
(“start bar code”) digit. Default is “Send”.
•
Code ID is a user-definable identification letter for EAN-13, which
is referred to in the “Use Code ID” function (see page 11).
Default is letter “F”.
•
Enabled toggles the ability for the keyboard/scanner to read
EAN-13 on or off. Default is “Yes”.
•
UPC-E
Enable NSC=1 allows the output of a UPC-E bar code with a first
digit of “1”. Default is “No”.
•
Zero Expansion adds 0s to the bar code output to change the
output format to UPC-A. Default is “No”.
•
Send Check Digit toggles whether or not to send a check digit.
Default is “No Send”.
•
Send Leading Digit toggles sending or not sending a leading
(“start bar code”) digit. Default is “Send”.
•
Code ID is a user-definable identification letter for UPC-E, which
is referred to in the “Use Code ID” function (see page 11).
Default is letter “E”.
•
Enabled toggles the ability for the keyboard/scanner to read
UPC-E on or off. Default is “Yes”.
•