20
© 2023 Unitech Electronics Co., Ltd. All rights reserved.
Unitech is a registered trademark of Unitech Electronics Co., Ltd.
All product and company names are trademarks, service marks, or registered trademarks of their respective owners
2.4.2 Read Mode
Single read: The terminal only reads one tag upon each press.
Please release the Power / Trigger Key and press again to read another tag.
The LCD screen will show the EPC code of the RFID tag being read (shown as
picture below).
Multiple read: The terminal can read multiple tags that are under RF
coverage upon each press. Keep pressing the Power / Trigger Key to read
the tags that have not been read. The tags that had been read will not be
read again, unless you release the button and press again.
When there is only one tag:
Shows the EPC Code of the tag being read.
Multiple tags being read:
Shows the amount of tags being read.
*Note: Please note that RP902 does not support continuous reading by single
press of trigger key for more than 15 seconds. Users need to release the
trigger key and press again to start a new round of reading.
To Next Page
Loading...
Need help?
General