24
© 2023 Unitech Electronics Co., Ltd. All rights reserved.
Unitech is a registered trademark of Unitech Electronics Co., Ltd.
All product and company names are trademarks, service marks, or registered trademarks of their respective owners
2.5 Reading RFID Tags
It is recommended to read RFID tags by aiming the antenna area of RP902 at
the RFID tag horizontally (as shown in the picture below.)
Reading distance may be impacted by the type of tag and environmental
conditions.
Reading range is 1m when power is 22dBm, and the maximum reading range
is 2m when power is 27 dBm.
2.6 RP902 Data Collection
Note: The tags that were being read will be saved in RP902 (with 7MB internal
buffer).
How to collect the data saved in RP902?
1. Getting Start → Enter the Setting page by short pressing the
Function/Select Up Key →Enter the Operating Mode → Select Buffer
Mode, and RP902 will restart.
2. Connect RP902 with PC through USB cable → Enter the USB disk
→ Open the file “inventory”
To Next Page
Loading...
Need help?
General