Need help?Do you have a question about the United Spa Controls C5 Series and is the answer not in the manual?
Emphasizes following basic safety precautions when using electrical equipment.
Warning: Children should not use spas or hot tubs without adult supervision.
Warning: Use spa only with all suction guards installed to prevent body and hair entrapment.
Install topside on an outward facing edge to avoid steam/moisture damage.
The T8-S topside requires a single 1.75" hole for installation.
Connect cable to topside and control box, then affix topside using adhesive tape.
Outlines powering up and programming the topside after installation for desired configuration.
Explains the 5 configuration codes that set system components and amperage.
Details the 5 configuration codes and their options for Jet-1, Jet-2, Aux, Power, and Heater operations.
Step-by-step instructions for entering the programming mode using button presses.
How to change options, cycle through codes, and save/exit the configuration menu.
Explains how to change selected options for each code and the time-out rule.
How to save changes and exit the configuration menu, either by pressing 'Aux' or by time-out.
Instructions for adjusting the water temperature using the '+' and '-' buttons.
How to operate Pump-1 in single or dual/triple pump systems.
How to operate Pump-2 when configured as single or dual speed pump.
How to operate auxiliary components like Pump-3 or Air Blower.
How to turn the spa light on/off and information on multi-function LED lights.
General| Brand | United Spa Controls |
|---|---|
| Model | C5 Series |
| Category | Control Panel |
| Language | English |
To Next Page
