FROTHING MILK/ MAKE CAPPUCCINO
You get a cup of cappuccino when you top up a cup of espresso with frothing milk.
Note: during making steam, the metal funnel must be assembled in position.
Method:
1. Prepare an espresso with container big enough according to “MAKE ESPRESSO
COFFEE”, section make sure that the steam control knob is at the OFF position.
2. Press down ON button for espresso coffee, the indicator of ON (red indicator) is illuminated, the
green indicator is flashed on the position. You should press the PUMP button, when there is
water flowing out and close the pump immediately. The purpose of the step is that pump the water of
the tank into the housing. Then press button, to make the green indicator is flashed on the
position.
Note: the pump can pump water only the green indicator is flashing or illuminating on the
position. Namely, when the green indicator is flashing or illuminating on the position, the
PUMP button is inactive.
3. The internal heating element until the green indicator is illuminated. You can make steam.
Note: During operation, if the green indicator is flashing, you must turn the steam control knob to
OFF position and press the PUMP button (first make sure there is water in the tank), after about 20
seconds, close the pump, and waiting until the green indicator is illuminated again, turn the steam
control knob in an anti-clockwise direction, and steam will be produced again.
3、Fill a jug with about 100 grams of milk for each cappuccino to be prepared, you are recommended
to use whole milk at refrigerator temperature (not hot!).
Note: In choosing the size of jug, it is recommend the diameter is not less than 70mm, and bear in
mind that the milk increases in volume by 2 times, make sure the height of jug is enough.
4、Insert the frothing device about two centimetre into the milk, turn the steam control button in
anti-clockwise slowly, steam will come out of the frothing device. Froth the milk in the way moving
vessel round from up to down.
Note: Never turn the steam control button rapidly, as the steam will accumulate rapidly in short time
which may increase the potential of the risk of explosion.
5. When the required purpose is reached, you can turn the steam control knob to OFF position and
press the button to make the green indicator is flashed on the position. The steam will
not come out.
Note: Carefully clean frothing device with wet sponge immediately after steam stops generating.
7、Pour the frothed milk into the prepared espresso. Sweeten the cappuccino to taste and if desired,
sprinkle the froth with a little cocoa powder.
8、Switch off the appliance by pressing the ON button once.
Note: we recommend you allow the maker to cool down at least for 5 min before making coffee again.
otherwise burnt odor may occurred in your next espresso coffee .
PRODUCING STEAM TO HEAT LIQUIDS
The steam tube (without the frothing device) can be used to make hot beverages like drinking chocolate,
water or tea.
Fig.4
To Next Page
Loading...
