SECTION A, PAGE 1
A1. UNPACK: Carefully unpack system and inspect for damage. Report any
problems to the factory at once. If damage is obvious from outside of carton,
photograph the damage and report to carrier immediately.
A2. LOCATION: Select location for power supply cabinet being sure that the
cabinet door will clear all welder components when open. It is usually an advantage
to locate this cabinet as close to eye level as possible for easy installation and
servicing.
A3. MOUNTING: Select the model number group:
A3.1 FOR 9180i, 9180iD, AND 9180iL, SERIES CONTROLS:
Drill welder to match the four mounting ears mounted to the cabinet. Install cabinet.
A3.2 FOR 9180iM SERIES CONTROLS: Side
mounting brackets are supplied with the system.
a. SIDE MOUNTING: You can mount the control from the left
or right side as desired using the two mounting brackets
supplied with this control. Mount these brackets using the
screws that presently hold the side panel in place per the
photo at the right. Mount cabinet.
b. BOTTOM MOUNTING: Alternately, by drilling holes in the
four foot pads on bottom of this enclosure, you can mount
the control to the top surface of the welder or to a table top.
IT IS IMPORTANT THAT NO METAL CHIPS ENTER ANY OF THE
ELECTRONIC COMPONENTS IN THE CABINET! PROTECT POWER
SUPPLY AND CONTACTOR DURING THE FOLLOWING DRILLING
AND INSTALLATION OPERATIONS. WHEN COMPLETE, REMOVE
ALL CHIPS FROM THIS CABINET BEFORE APPLYING POWER.
Take your time installing this new SOLUTIONi control. Be sure that
all connections are tight and that no chips get into the control
components.
To Next Page
Loading...