SECTION C, PAGE 12
To select the desired mode, press:
The display will show:
If you do not want to read welding current, press and the display will exit out.
If you do want to read the current, press and the display will show:
C9.1: DISPLAY ONLY: If you push 1 the average RMS welding current will
be displayed after each weld, but the control will not compare it to anything and
will not indicate if an out-of-range weld has been made.
C9.2: COMPARE TO LIMITS: If you
push 2, the average RMS welding current will
be displayed after each weld, and the control
will compare it to the HIGH CURRENT LIMIT
and LOW CURRENT LIMIT in the welding program:
If the measured average RMS welding current in a weld goes above the HI CUR
LIMIT, the display will show:
HIGH CURRENT: The on the right
indicates current read was higher than the
HI CUR LIM. Line in the welding program.
If the control was set in C5 for AUTOMATIC
fault reset, the control will reset without any other action.
CURRENT READ MODE:
TURN READING OFF =3
Want to change? Push
the YES or NO button
CURRENT READ MODE:
DISPLAY ONLY =1
COMPARE TO LIMITS =2
TURN READING OFF =3
HI CUR LIM.00,000A←
LO CUR LIM.00,000A
PROGRAM 001 IN USE
CUR.ERROR=08,750 A
CLOSE INITIATION
to OPEN ELECTRODES
To Next Page
Loading...