16 17
Operating instructions
Your hearing aids may come with two controls
that allow you to further adjust them – a rotary
dial and a push button.
Rotary dial - volume control
The rotary dial on your hearing aids can
be set up as a volume control. If the
rotary dial has been congured as a
volume control:
• Rotate dial slowly forward towards your nose
to increase the volume.
• Rotate the dial slowly backward away from
your nose to decrease the volume.
As you change the volume level, your hearing
aids will beep.
Volume setting Beeps
Suggested volume level 1 beep
Turning volume up short beep
Turning volume down short beep
Maximum volume level 2 beeps
Minimum volume level 2 beeps
Push button - program control
Your hearing aids may be equipped
with a push button which can be used
to switch between programs.
If the push button has been congured as a
program control, each time you push the button,
you will move to a new hearing aid program.
Your hearing aids beep to indicate which
program you are in.
Program 1 (e.g. AutoMic) 1 beep
Program 2 (e.g. speech in noise) 2 beeps
Program 3 (e.g. telephone) 3 beeps
Program 4 (e.g. music) 4 beeps
Please see the front of this booklet for a listing
of your personalized programs.
To Next Page
Loading...
