54 55
Use of accessories, transducers and cables
other than those specied or provided by the
manufacturer of this equipment could result
in increased electromagnetic emissions or
decreased electromagnetic immunity of this
equipment and result in improper operation.
Portable RF communications equipment
(including peripherals such as antenna
cables and external antennas) should be
used no closer than 30 cm (12 inches) to any
part of the hearing aids, including cables
specied by the manufacturer. Otherwise,
degradation of the performance of this
equipment could result.
The USB-C port of the charger is to be used
for the described purpose only.
For charger, use only IEC 60950-1 *, IEC
62368-1 or IEC 60601-1 certied equipment
with an output rating of 5 VDC. Min. 500 mA.
* Note: this standard may not be valid anymore in your country, please refer
to IEC 62368-1
The following is only applicable for persons
with active implantable medical devices
(i.e. pacemakers, debrillators, etc.):
- Keep the wireless hearing aids at least 15
cm (6 inches) away from the active implant.
- If you experience any interference, do not
use the wireless hearing aids and contact
the manufacturer of the active implant.
Please note that interference can also
be caused by power lines, electrostatic
discharge, airport metal detectors etc.
- Keep magnets at least 15 cm (6 inches)
away from the active implant.
- If using a wireless accessory, consult safety
information in your accessory user guide.
Use of this equipment adjacent to or stacked
with other equipment should be avoided
because it could result in improper operation.
If such use is necessary, this equipment and
the other equipment should be observed to
verify that they are operating normally.
To Next Page
Loading...
Need help?
General
