Apollo x6 Hardware Manual Introduction 8
Audio Interface Features
• Sample rates up to 192 kHz at 24-bit word length
• 16 x 22 simultaneous input/output channels
• 6 channels of analog-to-digital conversion via mic, line, or high-impedance inputs
• 12 channels of digital-to-analog conversion via:
• 6 mono line outputs
• Stereo monitor outputs
• Two stereo headphone outputs
• 10 channels of digital I/O via:
• Eight channels ADAT Optical I/O with S/MUX for high sample rates
• Two channels coaxial S/PDIF I/O with sample rate conversion
• Two Thunderbolt 3 ports facilitates daisy-chaining of other Thunderbolt devices
Microphone Preamplifiers
• Two high-resolution, ultra-transparent, digitally-controlled analog mic preamps
• Unison
™
technology for deep integration with UAD preamp, amp, and pedal
plug-ins
• Front panel and software control of all preamp parameters
• Switchable low cut filter, 48V phantom power, pad, polarity inversion, and stereo
linking
Monitoring
• Stereo monitor outputs (independent of the eight line outputs)
• Front panel control of monitor levels and muting
• Two stereo headphone outputs with independent mix buses
• Independent front panel volume controls for headphone outputs
• Front panel pre-fader metering of monitor bus levels
• S/PDIF outputs can be set to mirror the monitor outputs
• Up to two alternate stereo monitor outputs selectable via front panel or Console
software
• Assignable front panel monitor function switch for alternate speakers, dim, &
mono
UAD-2 Inside
• HEXA DSP featuring six SHARC
®
processors
• Realtime UAD Processing on all analog and digital inputs
• Same features and functionality as other UAD-2 devices when used with DAW
• Can be combined with other UAD-2 devices for increased mixing DSP
• Includes UAD Powered Plug-Ins “Realtime Analog Classics Plus” bundle
• Complete UAD Powered Plug-Ins library is available at the UA online store
To Next Page
