Bypass Mode
You can switch between Trails or True bypass modes using the slider switch on the back of the
pedal.
Trails - Reverb tails play out after the pedal is bypassed. The pedal’s output is buffered
when the effect is on and off. Trails bypass minimizes high frequency loss from long cable
runs, and preserves your tone when you have multiple pedals in series.
True - Reverb tails are cut off immediately when the pedal is bypassed. The pedal signal is
true bypass when the effect is off.
Predelay Mode
You can switch predelay on and off for Evermore’s reverb signal using the slider switch on the
back of the pedal.
Off - Normal mode; there is no predelay on the reverb signal.
On - Predelay is added to the reverb signal; you hear a slight delay before the onset of
reverb. Use predelay to preserve your instrument’s attack, and present a slightly cleaner
reverbed signal.
Evermore Specifications
Note: All specifications are subject to change without notice.
Power requirements
(power supply sold separately)
Isolated 9VDC, center-negative, 250 mA minimum
Inputs ¼” unbalanced TS
To Next Page
Loading...
