Speaker Drive
This control adjusts the dynamic response of the speaker cabinet. This unique and powerful
control adjusts different aspects of OX Stomp's Dynamic Speaker Modeling.
At lower settings, the cabinet sounds more like the speakers are new. As you increase this
control, the cab gets softer and spongier with more breakup, like a broken-in speaker.
At higher ranges, breakup is more obvious, with crumbling of the lows and smearing of the
highs as the speaker is pushed harder. At the highest ranges, the speaker approaches the end
of life: weaker, looser, and darker. Sub-octave notes (cone cry) may be apparent with certain
note/cab combinations.
Note: The Speaker Drive control is not available in the UAFX Control app.
Output
Controls the level of the pedal output.
Note that to optimize the sonic quality of OX Stomp's extensive interactivity between its
complex modeling components, the output level is lower than other UAFX pedals. Typically, the
output level will match the input level between 3 o'clock and maximum. However, the level and
panning of each individual mic also affects the overall output volume.
Mic 1 / Mic 2
Controls the level of microphone 1 and microphone 2 in the overall pedal mix.
Rig
Selects a Rig. The Rig you select is assigned to the active footswitch (if not in Delay | Reverb
mode). Other Rigs can be assigned to the Rig knob with the UAFX Control app.
Mic 1 Select / Mic 2 Select
Selects the mic used for Mic 1 or Mic 2.
To Next Page
Loading...
