Amp emulator split to guitar amp (without OX
Stomp effects) and front of house (with OX Stomp
cabs/effects)
You can split your amp emulator's outputs between a guitar amp and OX Stomp. With this setup
you can have your amp sound on stage without the OX Stomp effects, and a mono or stereo
front of house signal with the OX Stomp effects and the mic'd cab sound.
The advantage of this connection setup is that you don't have to configure any special speaker
panning or save any specific sounds in OX Stomp. The disadvantage is that you aren't using OX
Stomp effects with your guitar amp. See this connection example to use OX Stomp effects
with your guitar amp.
Connect your instrument to your amp emulator input.
Turn off cab emulation on your amp emulator.
Connect one output from your amp emulator to your guitar amp input.
Connect the other output from your amp emulator to the OX Stomp 1/MONO input.
Connect one or both outputs from OX Stomp to the mixer or front of house.
To Next Page
Loading...
