Universal Laser Systems VLS3.60 User Manual (English)

To Next Page

VLS Service Manual

Table of Contents

Enclosure and Cart

Page | 42

Enclosure and Cart

3. With the assistance of another person, place the system on top of the cart, aligning the pins on the cart

with the alignment holes on the bottom of the system, and loosely install the 4 socket head screws, 4

locking washers, and 4 ﬂat washers attaching the system to the cart. These screws will go through the

cart legs into the bottom of the system.

4. Using the two remaining screws, ﬂat washers, and locking washers, attach the back panel to the rear of

the system.

Cart

VLS3.60 and VLS4.60

NOTE: Leave all the screws slightly loose except for the casters.

1. Screw the 4 casters onto each leg, 2 per leg, as far as possible.

2. Attach the back panel to the legs using the 4 socket head screws, 4 locking washers, and 4 ﬂat

washers.

Other manuals for Universal Laser Systems VLS3.60

Need help?

Do you have a question about the Universal Laser Systems VLS3.60 and is the answer not in the manual?

General