Need help?Do you have a question about the Universal Laser Systems VLS3.60 and is the answer not in the manual?
General| Laser Type | CO2 |
|---|---|
| Work Area | 24 x 12 in (610 x 305 mm) |
| Resolution | Up to 1000 dpi |
| Weight | 200 lbs (91 kg) |
| Max Material Thickness | 8 in (203 mm) |
| Connectivity | USB, Ethernet |
| Maximum Part Size | 24 x 12 inches (610 x 305 mm) |
| Software | Universal Control Panel (UCP) |
| Supported File Formats | BMP, DXF, GIF, JPG, PDF, PNG |
| Power Requirements | 100-240 VAC, 50/60 Hz, Single Phase |
Definitions created by the laser industry council to indicate degrees of laser emission and safety requirements.
Explains how to operate the laser system using the Universal Control Panel (UCP) and its tabs.
Details advanced settings and controls for engraving and vectoring via Manual Control.
Instructions for setting up popular graphics software to work with the laser system.
Covers installation and operation of Air Assist Back Sweep, Compressor, and Cone.
Instructions for installing cutting table and High Power Density Focusing Optics.
Guide for installing, operating, and calibrating the Rotary Fixture for cylindrical objects.
Procedures for cleaning the laser system's motion system, enclosure, and optics.
Recommended schedule for cleaning and inspecting laser system components for optimal performance.
Step-by-step instructions for proper installation and setup of the laser system.
Guidelines for site preparation, computer, and software setup for optimal operation.
A guide to performing the first engraving project using the laser system.
To Next Page
