Universal Remote Contorl RM-1 User Manual

RM-1 OWNER’S MANUAL
Join to Network
This feature is only used by the installer at the
remote's initial setup. You will only need to
access this screen if directed by your installer or
technical support. Press the MAIN button to exit
the Join to Network screen. If you do not press a
button, it will timeout after 5 minutes.
Specifications
Microprocessor: ARM7TDMI
RAM: 8Mbit SRAM
FLASH: 32Mbit Nor FLASH
Display: 1.46” PMOLED (128 x 128)
RF Range (radio frequency): 50 to 100 feet, depending upon the
environment
RF Frequency: 2.405~2.480GHz
Provides: Two-Way communication with CP-1(or higher) network
system controller.
Weight: 8.5 oz. (with battery)
Size: 8.7”H x 2.2”W x 1.3”D
Battery Life: 18 Hours of continuous button pressing with back-
lighting and LCD ON (months of use for most users).
Users should expect some variation based on the
brand of alkaline batteries used.
Note: In actual use, the RM-1 protects itself if it gets stuck between
couch cushions (with a button being continuously pressed).
After 30 seconds the RM-1 will turn off, and will
not turn on again until the button is released.
Page 6

Universal Remote Contorl RM-1 Specifications

General

Brand	Universal Remote Contorl
Model	RM-1
Category	Remote Control
Language	English