7?A<
=>
Frequently Asked Questions
%,*#*)6$ ++)*++-#)0 %*+## %+*0*+$+&&%7
%++&+7?A<1
Yes, the flashers are compatible if they use 3.5mm mono mini plugs with the same
polarity (Tip is data, sleeve is ground).
5$++ % %&%* *+%+&')+ &%))#**&#*)#-#&)'&* + &%4
Some components are easily overloaded with IR from nearby flashers. Prevent IR from
affecting the problem component from other flashers or the front panel blaster by set-
ting the device to a specific IR Line Output instead of ALL, then adjust the Line Output.
-)&.& %+ #*45-&))+#0*++#*)&,+',+*,* %+
+&)*&+.)20+.%*%&$$%+&&%&+$2+%/+
+&+*#+#*&)*'&%*4&.&*+&'+ *1
First, check the RF ID#, if the RF ID# is set to 0, IR routing does NOT work. The RF ID#
from 1-9 or A-F must be set on both the remote control and the bottom of the MRF-
350, second, check that the flasher level is set to the minimum necessary, third, check
that the emitter is facing the component, fourth, make sure the RFX-250 is correctly
connected to the MRF-350 RF Inputs (Step 4, Page 3)
To Next Page
Loading...
