Universal UCS Series - Use Set Configuration

Universal Chilling Systems, LLC.
14
Manual Model 10 Air Cooled Chiller
Select weekday by and , press OK to change the state. If there is > before the
weekday, it means on the weekday the automatic ON/OFF will act, if no >, the ON/OFF will not be
acted automatically.
In C face, select DATE TIMING by and , press OK to enter DATE TIMING, the show is
below:
DATE: 2005 / 01 / 01
2005 / 01 / 01
Select the item to be changed by and , press <+> , <-> to change the item.
In b or c face, select SET CLOCK by and , press OK to enter time set page as below:
ON: 07h 59 m
OFF: 22h 30 m
Select the item to be changed by and , press <+>,<-> to change the item.
The data will be kept in memory after the power is off. After the change, press RETURN to come
back to menu of up level.
ii) USE SET
In user's page, select USE SET by and , it will show as below:
COMP.1: NONE
COMP.2: USE
The show depends on the number of compressor and heater in RUN SETTINGS  SYS. SETTINGS and
mode of OUTPUMP. The energy adjustment and trouble check will not be available in case the
compressor or heater is set at NONE.
Select the item to be changed by and , press <+>,<-> to change the item. The data will be
kept in memory after the power is off. After the change, press RETURN to come back to menu of up
level.