AUTOMATIC MODE OPERATING INSTRUCTIONS CONTINUED
Warning: Never attempt to adjust, load or unload the carriage while the slicer is in automatic
operation!
Warning:
If the product needs to be adjusted during automatic slicing, always press the “set off”
button (Figure 4 [4]). Turn the operating mode switch (Figure 3 [2]) to the neutral (center)
position. Pull the carriage all the way towards you. Turn the slicer OFF and close the fence
prior to adjusting the product and the last slice device.
9. To stop automatic slicing operation, press the “set off” button (Figure 4 [4]). Turn the operating
mode switch (Figure 3 [2]) to the neutral (center) position. When using the counting device, the
slicer will automatically stop after the set number of slices have been sliced. You can also stop the
slicing operation in the middle of counting by pressing the “set off” button (Figure 4 [4]).
10. When the carriage has stopped, pull the carriage all the way towards you. Turn the slicer OFF by
pressing the on/off rocker switch (Figure 2) to the off position. The switch will no longer by
illuminated. Always turn the slice adjustment knob past “0” to completely close the fence.
11. You can now load or unload product from the carriage.
Page 9
To Next Page
Loading...
Need help?
General
