Univex 6509 - User Manual

Questions and Answers

R
rmartinJul 27, 2025
Why is my Univex Kitchen Appliances slicer not working?
- C
  Charles GarciaJul 27, 2025
  If your Univex Kitchen Appliances slicer isn't operating, several issues could be the cause. First, check your electrical service, replacing any blown fuses or resetting tripped circuit breakers. If the electrical service is fine, the switch contacts may be burned, requiring switch replacement. A defective motor capacitor or a burned-out motor could also be the reason; in these cases, replace the capacitor or remove, test, repair, or replace the motor.
H
Heather White MDJul 31, 2025
What to do if Univex 6509 slicer motor stalls?
- S
  Sherri MorganJul 31, 2025
  If the motor in your Univex Kitchen Appliances slicer stalls during slicing, it could be due to several reasons. The knife's cutting edge might be dull or improperly sharpened, requiring you to sharpen it carefully, using the honing stone for only 1 to 2 seconds. Alternatively, the product you're slicing, such as old and dried-out cheese, might be the issue; try reducing the slice thickness. Low voltage service could also cause the stalling; in that case, have an electrician check the service voltage. Finally, excessive belt tension could be the culprit, so readjust the belt tension.
A
Alexandria SimmonsAug 6, 2025
How to reduce noise from Univex Kitchen Appliances slicer?
- T
  tinadavisAug 6, 2025
  Excessive noise in your Univex Kitchen Appliances slicer can stem from several sources. The knife might be contacting the knife guard; try tightening the knob that secures the guard. A badly worn or frayed drive belt could also cause noise, so replace the belt if necessary. Misalignment of the motor pulley and belt is another possibility; realign the motor pulley. Check for a loose set screw in the motor pulley and tighten it. Finally, a dirty knife rubbing against the plastic scraper can generate noise; clean both the knife and the plastic scraper.
D
danielle56Aug 10, 2025
Why does the knife slip when slicing with my Univex Kitchen Appliances slicer?
- Q
  qboyerAug 10, 2025
  Knife slippage during slicing with your Univex Kitchen Appliances slicer can be attributed to a loose belt. In this case, tighten the belt tension. Also, grease or oil on the belt can cause slippage. Clean the pulleys with a safety-approved cleaning solvent on a soft, clean rag and consider replacing the belt.
F
fmurilloAug 15, 2025
Why Univex Kitchen Appliances slicer motor hums but won't turn?
- H
  Haley DunlapAug 15, 2025
  If the motor of your Univex Kitchen Appliances slicer is straining but not turning, producing a humming sound, the belt tension may be too tight. Readjust the belt tension. Note that after long periods of disuse, the belt may take a set in the pulley ribs. Gently urging the knife with a wooden stick might start the slicer. Do not use your hands to turn the knife.
J
Jason JeffersonAug 20, 2025
What to do if Univex 6509 Kitchen Appliances slicer smears soft cheese?
- M
  Matthew DavisAug 20, 2025
  Smearing or tearing when slicing soft cheese with your Univex Kitchen Appliances slicer can occur if the soft cheese is at room temperature; chill the cheese for best slicing results. Alternatively, the knife may be dirty with hard, dried-on product; clean the knife thoroughly.