Univex Duro 7510 - User Manual

Questions and Answers

J
Jonathan BanksAug 1, 2025
Why is my Univex Kitchen Appliances slicer not operating?
- D
  Daniel SotoAug 1, 2025
  Your Univex Kitchen Appliances slicer might not be operating due to several reasons: * Electrical service interruption: Check the electrical service and replace the fuse or reset the circuit breaker if necessary. * Burned switch contacts: Clean or replace the switch. * Defective motor capacitor: Replace the capacitor. * Burned out motor: Remove, test, and either repair or replace the motor.
M
melissa38Aug 6, 2025
What to do if my Univex Duro 7510 Kitchen Appliances slicer motor stalls during slicing?
- B
  beth94Aug 6, 2025
  If the motor stalls during slicing, here are a few potential causes and solutions: * The knife cutting edge may be too dull or improperly sharpened: Sharpen the knife as specified, being careful not to use the homing stone for more than 1 or 2 seconds. * The product, such as cheese, may be old and dried out: Reduce the thickness of the slice. * There may be low voltage service: Have an electrician check the service voltage. * The belt tension may be excessive: Readjust the belt tension.
C
Charles YoungAug 10, 2025
How to fix excessive noise from Univex Kitchen Appliances slicer?
- R
  Rodney DavidsonAug 10, 2025
  Excessive noise from your Univex Kitchen Appliances slicer can be caused by several factors. Try these solutions: * Knife contacting the knife guard: Tighten the knob that secures the guard. * Badly worn or frayed belt: Replace the belt. * Motor pulley and belt misaligned: Realign the motor pulley. * Loose set screw in motor pulley: Tighten the set screw. * Dirty knife rubbing against plastic scraper: Clean the knife and plastic scraper.
J
James SmithAug 16, 2025
Why is my Univex Duro 7510 slicer knife slipping during slicing?
- S
  stephengeorgeAug 16, 2025
  Slippage of the knife during slicing can occur due to: * A loose or broken belt: Adjust the belt tension or replace the belt. * Grease or oil on the belt: Clean the pulleys with a safety-approved cleaning solvent on a soft, clean rag. Replace the belt if necessary.
C
Christopher WalkerAug 21, 2025
What to do if Univex Kitchen Appliances slicer is smearing or tearing soft cheese?
- L
  Linda Doyle DDSAug 21, 2025
  If your slicer is smearing or tearing soft cheese, it could be due to: * Soft cheese at room temperature: Chill the soft cheese for best slicing results. * Knife dirty with hard dried on product: Clean the knife thoroughly.
P
Phillip BassAug 27, 2025
Why is the blade not turning on my Univex Duro 7510 Kitchen Appliances slicer, but the motor is running?
- C
  churchchristinaAug 27, 2025
  If the motor is running but the blade isn't turning, the belt tension may be too tight. Readjust the belt tension.