Uniwill 340S2 - Page 70

Chapter 5 Troubleshooting Guidelines
340S2 70 Rev : B
5.16 Stopping in LCD screen while booting
Check Memory
Size is correct?
Check HDD detection
is OK?
Check CD-ROM
Detection is OK?
Record LCD message &
to Board–level
Troubleshooting
Make sure HDD is good
&Check BIOS setting
Make sure CD-ROM
Is good & Check BIOS
Settings
Re-soldering
No
Yes
No
Yes
No
Yes
Stop in LCD screen while booting
Stop in LCD Screen while
booting
Check CPU &
SIS630 for cold
soldering? OK?
Check one of the following parts or signal on the M/B
may be defective, use an oscilloscope to check it.
No
Yes