To Next Page
D
david51Aug 10, 2025
How to fix first layer not sticking Uniz Slash OL 3D Printers?
- KKatherine DeleonAug 10, 2025
If the first layer isn't sticking correctly, follow the z-axis calibration procedure and calibrate again.
How to fix first layer not sticking Uniz Slash OL 3D Printers?
If the first layer isn't sticking correctly, follow the z-axis calibration procedure and calibrate again.
How to remove stripy or grainy defects on Uniz Slash OL?
To address stripy or grainy defects on the printed model, replace the resin tank with a new one and clean the residual resin on the screen.
How to prevent edge warp defects on Uniz 3D Printers?
To prevent edge warp defects on the printed model, manually add the supports, following the provided guidance.
Why is my Uniz 3D Printers LCD flickering?
Abnormal LCD performance, such as no display, flickering, or different display on the left/right side, may occur if the LCD panel is overheated. Allow it to cool down, or replace the LCD panel following the provided guidance.
Why is the front light displaying abnormally on Uniz Slash OL 3D Printers?
If an abnormal display appears on the front light of the printer, it may be due to a circuit board cable or program error. Reinsert the cable and restart the printer.
How to fix light leaks outside the screen area on Uniz Slash OL 3D Printers?
If an excessive printed part appears due to light leaks outside the screen display area, pierce either top hole of the resin bottle with the provided awl.
General| Brand | Uniz |
|---|---|
| Model | Slash OL |
| Category | 3D Printers |
| Language | English |
