To Next PageTo Next PageWhy does the tarp sag in the middle areas on my Unverferth 8250 Farm Equipment?
If the tarp on your Unverferth Farm Equipment sags in the middle areas, the bows might be bent or adjusted too low. Also, check for a missing or loose ridge strap, and replace or retighten it as necessary. Another possible cause is that the tension is too loose, so you may need to adjust the U-joint on the splined shaft to provide more tension.
Safety warnings about operator responsibility and care.
Importance of replacing and maintaining safety decals.
General guidelines for safe operation and maintenance.
Pre-operation checks and safety precautions.
Safe practices while operating the equipment.
Safety measures for preparing the machine for transport.
Guidelines for safe transportation of the machine.
Precautions for safe use of the driveline.
Hazards and safety procedures related to pressurized hydraulic oil.
Steps to take for emergency preparedness.
Checks and preparations for the tractor before use.
Service checks and preparations for the grain cart.
Safety guidelines and procedures for towing the implement.
Operation of the PTO-driven auger.
Operation of the hydraulically-driven auger.
Detailed lubrication points for the cart.
How to check and verify PTO shaft length.
Maintenance and lubrication of PTO shaft and clutch.
Procedures for PTO quick disconnect maintenance.
Torque specifications for wheel nuts.
Torque specifications for various hardware.
Parts list for the PTO assembly.
Parts list for the PTO clutch.
General| Model | 8250 |
|---|---|
| Category | Grain Cart |
| Manufacturer | Unverferth |
| Capacity | 850 bushels |
| Auger Diameter | 20 inches |
| Hitch Type | Pintle |
| Construction | Steel |
