UPM Elite THM701 - Getting Started; Select C or F

CELSIUS DEFAULT: Since Celsius (°C) is the default mode no action
is required to use the thermostat in this mode.
(°C or °F) It is VERY IMPORTANT that you choose Fahrenheit (°F) before
you begin using the thermostat. If you proceed to set the clock and program
settings with the default Celsius(°C)and THEN change to the Fahrenheit (°F)
setting; the clock, programs and all system settings will be deleted.
IMPORTANT - Getting Started
** **
4
Select ºC or ºF (Celsius or Fahrenheit)
Press OPTION for 3 seconds just after batteries are installed.
Select Option oP9 with the (left) arrows to choose between °F or °C mode.
To choose Fahrenheit select value 1 with the (right) arrows. (1=°F)(0=°C Default)
Press OK to exit
(*see option section for more details)
2
1
3
4