2 inches
6
5. The set comes with 2 clamps per pole.
One being attached 2” below frame,
while the other being attached 2” above
the end of the lower pole.
6. Feed the screw through the screw hole
thus tightening the clamp to securely
connect it to your trampoline leg with the
tool included.
7. Now you can have the upper part of the
pole inserted into the lower part that is
already attached to the leg.
8. Repeat the steps above to have all your
enclosure poles connected securely to
your trampoline legs.
7
2 inches
9. 9. After connecting all Enclosure Poles insert the Pole caps, if you have an Inside Type Net
use part number E1 and for outside type Net use E2
E1
E1
E1
E1 E1
E1
E1
E1
E2
E2
E2 E2
E2
E2
E2E2
For inside Type Net E-1 For outside type Net E-2
After you installed the Poles you should install the Enclosure Net, for intructions how to install the
Enclosure Net see Bellow the inside type model and the outside type choose the one applies to
your purchase,
To Next Page
Loading...
