1.
Introduction
1 - 1
Section 1
1.
Introduction
1.1 I
NTRODUCTION
P
URPOSE
& L
IMITATIONS
This Service & Parts Manual is designed to provide instructions and illustrations for the
safe operation and maintenance of the MB20N & MB26 Work Platform manufactured by
Upright Powered Access Ltd. The purpose of this machine is to provide fast and safe
access to difficult to reach areas. The machine may only safely operated on firm level
ground. Refer to the Specification section for the machines access limitations.
DO NOT use on soft ground or on slopes greater than 2 degrees.
DO NOT use the lifting mechanism to raise or lower goods or persons except within the
cage and subject to the weight limitations.
DO NOT enter the platform from a structure, rack or other platform.
S
COPE
This manual includes the procedures and responsibilities for the inspection,
transportation, safe operation, maintenance, and repair of this product. The
Maintenance Section within the Parts & Service Manual also covers preventative
maintenance and troubleshooting.
S
PECIAL
I
NFORMATION
Throughout this manual the users attention is drawn to these special warning boxes:
1.2 G
ENERAL
D
ESCRIPTION
The MB20/26 are self propelled, fast acting aerial work platforms, designed to raise two
operators with hand tools to a platform floor height of 6.00 m and 7.76 m respectively.
The accessible height is approximately 2.00 m above these figures. It is designed to
travel with safe working load and work tools up to an upper limit of 215 kg (475 lbs). The
unit offers the ability to reach over obstacles but must be used on firm and level ground
at all times.
DANGER
! !
Indicates an imminently hazardous situation which, if not avoided, will
result in severe injury or death.
WARNING
!
!
Indicates a potentially hazardous situation which, if not avoided,
could result in severe injury or death.
CAUTION
!
!
Indicates a potentially hazardous situation which, if not avoided, may
result in minor or moderate injury.
To Next Page
Loading...
Need help?
General
