ENGINE OIL REPLACEMENT
I Place the machine on a level surface and warm up the engine for several minutes. Then stop the engine.
II Remove the oil filler cap.
[[1 Place an oil pan under the engine. Remove the oil drain plug so that the oil can be completely drained.
IV Check the oil drain plug, gasket, oil filler cap and "o"-ring. If damaged replace.
V Reinstall the oil drain plug.
V[ Add engine oil to the upper level.
Recommended oil:
ASAE#30 OR 10W-30 OR 10W-40
B SAE #20 OR 10W-30 OR 10W-40
C SAE 10WOR 10W-30 OR 10W-40
Above 35" C (95F) : SAE #40
NOTE:
Recommended engine oil classification:
API Service " SE " or "SF "; if not available, "SD".
• Be sure no foreign material enters the crankcase.
AIR FILTER MAINTENANCE
• Clean regularly washing in a cleaning solvent.
• Do not wring out the element. This could cause it to tear.
• When replacing the filter, be sure the filter's sealing surface matches the air filter housing so there is no air
Leak.
• The engine should never run without the air filter properly installed. Excessive piston
And or cylinder wear may result in operating without the air filter properly installed.
WARNING
Never refilel while smoke or in the vicinity of an open flame.
SPARK PLUG INSPECTION
Standard electrode color: Tan Color
Spark Plug Gap:0.
7-0.8mm(0.028-0.03 lin)
FUEL TANK FILTER
@ Clean with soh, ent.
(2) Wipe off.
Read carefully before attempting to assemble, install, operate or maintain the product described. Protect
yourself and others b)' observing all safety information. Failure to comply with the user' manual could result
in personal injure and/or property damage! Retain the user's" manual for fitmre reference. Call toll free
number 866 797 2 738 for parts and service.
To Next Page
Loading...
