Board Diagram
Please follow installation steps as below
Please check the following accessory, if you find the item lost, please contact our local
dealer.
PoE Injector 1pc
AC Power Cable 1pc
Power Buckle 1pc
User Manual 1pc
(1) Turn off the system's power before the installation;
( ;
(3) The Data Input of this injector is connected with switch of no PoE fuction;
(4) Please connect PoE Injector with AC cable;
(5) Please examine and power the system.
2) The PoE Output port of this injector is connected with PoE IP Camera
Installation
This is a single-port PoE injector with one Ethernet port, one PoE output port, and one AC
input power port. It supports end-span PoE and the output power consumption is up to 60W; It
features:10/100M/1000Mbps network,100m transmission distance,6KV lightning protection,
industrial-level chip, and patent alert. it's an excellent choice for power supply and network
transmission on PTZ cameras, all-in-one PC, digital display system.
Features
1
2
Front
Back
Notice
The transmission distance depends on the signal source and cable quality,standard
Cat5e/6 cable is strongly suggested for reaching the maximum transmission distance!
Bayonet
Application
C
at
5
/
5e
/
6 Cab
l
e
Mon
it
o
r
NV
R
PoE IP camera
PoE IP camera
PoE IP camera
Et
her
ne
t Swi
t
ch
Po
E Injecto
r
PoE IP camera
PoE Injector
●
● Ultra PoE、IEEE 802.3af/at、IEEE 802.3 10Base-T/100Base-TX/IEEE802.3ab 1000Base-T;
● Higher conversion efficiency(90%); Lower heat radiation;
● Working Temperature: -10℃～55℃;
● 6KV lightning protection; 8KV ESD;
● No fan, no noise, dustproof;
● LEDs indicate operation status.
PoE++ power supply standard; Output power consumption up to 60W;
PoE Injector(Gigabit/60W)
User Manual
VerB 1.0
Connection Bayonet
Bayonet
Bayonet
Input power indicator
Output PoE indicator
To Next Page
Need help?
General