Rendering Machine V2______________________________________________________________________________________ 21
• Hook the trailer in the traction vehicle.
VERY IMPORTANT!
Keep in mind that the traction vehicle is certified to take this type of trailer.
• Control the closings of the hood and mixer to prevent that parts would come off during the road
transport.
7. Maintenance
7.1 Safety indications in the maintenance
! Do not remove safety features ! Mainly the protection grills.
! Never put the hand in the mix deposit or in the transport deposit with the machine on.
! Before beginning to work, make sure that nobody can set the machine on without permission.
! Only specialized personnel can handle the machine.
7.2 General indications
• Avoid the dirt in the lubricating points! Clean the lubricator and the lubricating pump before using it,
since the dirt and sand in the bearings cause premature waste.
• Lubricate the machine after each cleaning.
• Use only the mentioned lubricants and never mix different types since some oils are not compatible
to each other.
7.3 Daily and weekly lubricating points.
- Lubricate the bearings of the endless screw daily with the motor running.
- Lubricate once a week (every 20 hours of operation) the bearing of the mixer axle
left and right.
• Scrupulously clean the lubricating points.
• Lubricate until the grease is visibly coming out of the interior of the axle.
7.4 Daily maintenance
Before beginning to work:
• Check that that the transport hoses and the couplings are in good condition.
• Control the oil level of the diesel motor (if applies).
• Check the quantity of hydraulic oil.
• Check the level of oil of the air compressor.
• Control the quantity of fuel and fill it up if necessary.
After concluding the shift:
• Lubricate rotor and stator with a special silicone spray (ref. 41061288).
Supplied by :- Markham (Sheffield) Ltd - Tel:- +44 (0)1909 730861 - www.markham-sheffield.co.uk
To Next Page
Loading...