4
22. This product is intended solely for indoor, non-commercial, non-industrial use in temporarily heating
rooms. Do not use this product outdoors.
23. Do not operate the product continuously. Portable electric heaters are designed for nite space
heating or as a supplementary heat source. They are not intended to be main sources of heat during
the normal heating season.
24. Do not hang or wall-mount the product.
25. Place the product upright on a at, level, stable, heat-resistant surface.
This heater is for use on 120 volts. The cord has a plug as shown in Figure A. See Figure 1 for grounding
instruction. An adapter as shown at C is available for connecting three-blade grounding type plugs to
two-slot receptacles. The green grounding plug extending from the adapter must be connected to a
permanent ground such as a properly grounded outlet box. The adaptor should not be used if a three-slot
grounded receptacle is available. Always plug heaters directly into a wall outlet/ receptacle. Never use
with an extension cord or relocatable power tap (outlet/ power strip).
SAVE THESE
INSTRUCTIONS
B
A
C D
GROUNDING PIN
COVER OF GROUNDED
OUTLET BOX
METAL SCREW
ADAPTOR
GROUNDING
MEANS
GROUNDING
PIN
WARNING
To avoid injury from unexpected starting or electrical shock, do not plug the power cord into a source
of power during unpacking and assembly. The cord must remain unplugged whenever
you are adjusting/assembling the heater.
If any part is missing or damaged, do not attempt to use or plug in the power cord until the
missing or damaged part is correctly replaced. To avoid electric shock, use only identical
replacement parts when servicing double-insulated tools.
Fig.1
To Next Page
Loading...
Need help?
General
