Utilitech UT11501IGPP

Questions and Answers

H
hughesdavidAug 10, 2025
How to fix a Utilitech Swimming Pool Pump failure to pump or reduced pressure?
- D
  David StephensAug 10, 2025
  If your Utilitech Swimming Pool Pump isn't pumping effectively, it might be due to suction leaks causing a loss of prime. Ensure the pump volute and trap are full of water by priming the pump. Check for any leaks in the suction piping and confirm that the suction pipe inlet is well below the water level. A defective suction trap gasket could also be the culprit, so replace it if needed. Also, the pump should not be lifting water more than 10 ft. (3 m), and the suction pipe should be at least 1-1/2 in. (38 mm) in diameter. Another cause could be clogged components. Inspect the suction trap and impeller for any blockages, cleaning them as necessary. Worn impellers or diffusers can also reduce performance, requiring replacement parts.
A
Andrew MaddoxAug 18, 2025
What to do if my Utilitech Swimming Pool Pump is too hot?
- G
  ginakentAug 18, 2025
  If your Utilitech Swimming Pool Pump is running too hot, it could be due to several electrical issues or high ambient temperature. First, check the line voltage; if it's less than 90% or more than 110% of the rated voltage, consult a licensed electrician. Tighten any loose electrical connections. If the ambient temperature is too high, increase ventilation or reduce the ambient temperature to help the pump cool down.
R
Richard ValenzuelaAug 26, 2025
Why is my Utilitech Swimming Pool Pump so noisy?
- R
  Raymond ChangAug 26, 2025
  If your Utilitech Swimming Pool Pump is experiencing mechanical troubles and noise, it might be due to inadequate support for the pump or piping. If the suction and discharge piping are not adequately supported, the pump assembly will be strained. Additionally, avoid mounting the pump on a wooden platform; instead, securely mount it on a concrete platform for quieter performance. Cavitation, caused by the pump sucking air, can also lead to noise. Ensure the inlet piping is submerged in water, unobstructed, and that the pump isn't lifting water more than 10 ft.
S
stewartlisaSep 1, 2025
What to do if Utilitech Swimming Pool Pump is running slowly?
- D
  Diana RichardsSep 1, 2025
  If your Utilitech Swimming Pool Pump isn't pumping effectively, and you've checked for suction leaks, the issue could be the pump running too slowly. Check the voltage at the motor terminals and at the meter while the pump is running. If the voltage is low, refer to the wiring instructions or consult your power company. Also, check for any loose connections.