1. Screw in the legs.
2. Screw in the long handle for the door and shorter handle for the hopper lid. (Make sure the
little washer is between the wood and the door. This is really important as it will make sure
the handle won’t char).
3. Clean the baking surface with mildly soapy water and then with clean water. Then dry the
surface.
4. Place the Uuni on a non-ammable surface that is easy to clean.
5. Put the cradle halfway in from the rear and then put fan tunnel over it. It has to go so it
slopes down towards the main oven.
6. Follow the lighting instructions on the next page and re it for 20 minutes without putting
food in. This allows time for the paint to set. Note that during the rst ring, there will be
smoke rising from the surface of your Uuni.
Frs-tme etp
4
2
3
1
Oven
Oven door and handle
Legs
Hopper
Cradle
Fan tunnel
Air-ow regulator
Fan
1
2
3
4
5
6
7
8
Mke ur yu av:
U
u.n)