Uwatec AIR2 - Maintenance

12
7.2 Maintenance
Maintenance procedures beyond the simple operations described in the preceding
paragraphshouldnotbecarriedoutbytheuser.
A SCUBAPRO regulator must be overhauled by an authorized SCUBAPRO technician
every2years.Theservicingoverhauliscompulsorytopreservethelimitedlifetimewarranty.
PleaserefertotheJohnsonOutdoorswarrantyconditions.
SCUBAPROalsorecommendsthathighlyusedregulators(100dives/year+)undergoan
inspectionevery6monthsandanoverhauleveryyear.
ServicingisavailablethroughSCUBAPROAuthorizeddealersidentiedbytheSELECTED
DEALERSCUBAPROsignorbyvisitingwww.scubapro.com
!
WARNING
DO NOT USE silicone grease on the diaphragm and/or the exhaust valve, it may
cause damage to the silicone rubber.
Max Intermediate Pressure is 1.103 kPa (160 psig).
Using the AIR2 with rst stages exceeding this intermediate pressure may cause air
leakage from the mouthpiece and ination of the buoyancy vest.
AIR2SPECIFICATIONS
Materials:
- Case FiberglassReinforcedNylon
- Diaphragm SiliconeRubber
- ExhaustValve SiliconeRubber
- Spring StainlessSteel
- DemandValve Brass,ChromePlated
Performance:
Weight
(lessquick-disconnectandhose)
207grams(6.7oz.)
Average Flow Rates:
• DemandRegulator 1400liters/minute(at200bar)
• Inator
150liters/minute
(withintermediatepressureat6bar)
DemandValveDesign Downstream,VenturiAssisted
Hose
• Hose Lenght 70cm.standard
• Thread 3/8”standard