16
7.4.2 To Clear the Weight of a Container
from memory
Remove the container from hook then press
TARE. The tare indicator will go off
indicating no container weight is resided
in memory.
7.5 PLACING A LOAD
Always apply a load to hook gently. Sudden shock,
excessive force or overloading the scale may
cause damage to the weight sensor inside.
It is a good practice to remove all loads from
hook when not in used.
This would prolong the lifetime of weight
sensor.
7.6 WEIGHING FUNCTION
a. Before weighing, make sure that the Zero
Status Sign is on.
b. Press MODE until the required weight unit
appears.
c. Apply subject matter to hook and the weight
of it is displayed.
d. For best weighing result, refer to general
specification table for recommended
minimum weight to be applied.
To Next Page
Loading...