USING YOUR 3D PRINTED CUSTOM GRILL (SOLD SEPARATELY)
1. Remove the Remix Rings from their housing if present
2. Unscrew screws from the surface of Remix Speaker
3. Remove the pre-installed housing
4. Remove the pre-installed grill
5. Install and adjust the 3D printed custom grill onto the front of the Remix speaker
6. Install and adjust the housing (3D printed custom or the included one) onto the back
of the Remix speaker
7. Screw the screws in for a snug fit
The sound quality and acoustics performance of the Remix speaker may vary when 3D parts are installed in
place of the original parts. V-MODA will not be responsible for the product reliability and acoustics performance
after the 3D customization
To Next Page
Loading...