prompt
Please read this safety rule carefully before use.
After the equipment has been transported to the destination of use, please carefully open the package
and take out the equipment. If you find any defects, you should immediately contact the shipping
company and complain according to the defect. Confirm that this equipment is intact when it leaves the
factory.
Please check whether the received equipment matches the goods registered in the freight bill, and
whether the goods registered in the freight bill match
The goods you ordered are consistent, if not, please contact your supplier immediately.
Overview
This lamp is a professional lighting equipment designed for indoor and outdoor performances,
architectural lighting, etc. It is a wall washer and can be used as a lighting control lamp. The wires
marked as ground must be grounded.
Do not open the casing while this equipment is in operation to avoid electric shock.
Obvious defects are found in the glass lens, and the lens should be replaced immediately and its power
should be reduced, such as deep cracks or scratches. The luminous body should be replaced
immediately if it is damaged or distorted after high heat. When it is necessary to conduct inspection,
maintenance, repair and other operations inside the lamp, it should be handed over to professionals.
In the event of an accident, unplug the power cord before opening the lamp housing.
The user should operate within the scope of the specified use of this equipment and check whether the
wiring of the equipment is correctly connected. Please don't place the lamp in a changeable and harsh
environment.
The manufacturer is not liable for damage caused by unauthorized replacement of other types of light
sources.
This lamp is a kind of professional equipment. Although the improved design is simple and convenient to
operate, it still needs professional installation and maintenance.
Point
The power cord and other connecting devices are very important to the equipment, and their reasonable
arrangement leads to the safe and convenient use of the equipment.
When unplugging or plugging in the power supply, you must hold the plug and pull it out. Do not pull the
power cord directly.
Do not use the power cord in harsh environments. It should be tested before installation, and periodic
testing should be maintained after installation. Do not tie the power cord and other signal lines together to
prevent confusion.
Power connection
This lamp adapts to the normal voltage of 230V. For the safety of users, the ground wire (yellow-green)
must be kept grounded
ATTENTION:
LETHAL VILTAGE PRESENT INSIDE
To Next Page
Loading...
