prompt
Please read this safety rule carefully before use.
After the equipment has been transported to the destination of use, please carefully open the
package and take out the equipment. If you find any defects, you should immediately contact the
shipping company and complain according to the defect. Confirm that this equipment is in good
condition when it leaves the factory.
Please check whether the received equipment matches the goods registered in the freight bill,
and whether the goods registered in the freight bill match
The goods you ordered are consistent, if not, please contact your supplier immediately.
Overview
This lamp is a professional indoor lighting equipment designed for theaters, stage workshops, etc.
The wires marked as ground must be grounded.
Do not open the casing while this equipment is running to avoid electric shock.
When the lens is found to be defective, the lens should be replaced immediately and its power
should be reduced, such as deep cracks or scratches. The luminous body is damaged or distorted
after high heat and should be replaced immediately. If you need to perform inspection,
maintenance, repairs and other operations inside the lamp, you should turn it over to
professionals.
In the event of an accident, unplug the power cord before opening the lamp housing.
The user should operate within the scope of the specified use of this equipment and check
whether the wiring of the equipment is correctly connected. Please do not place the lamp in a
changeable and harsh environment.
The manufacturer shall not be liable for damage caused by unauthorized replacement of other
types of light sources.
This luminaire is a kind of professional equipment. Although the improved design is simple and
convenient to operate, it still needs professional installation and maintenance.
Point
The power cord and other connecting devices are very important to the equipment, and their
reasonable arrangement leads to the safe and convenient use of the equipment.
When unplugging and plugging in the power supply, you must hold the plug and pull it out. Never
pull the power cord directly.
Do not use the power cord in harsh environments. It should be tested before installation, and
periodic testing should be maintained after installation. Do not tie the power cord and other
signal lines together to prevent confusion.
Power connection
This lamp adapts to the local conventional voltage. For the safety of users, be sure to keep the
ground wire (yellow-green) grounded.
Warning:
Dangerous voltage inside!
To Next Page
Loading...
