First of all, thank you for choosing our company's product. Please read this instruction
manual carefully and completely, and keep it in a safe place for reference during use. This
manual contains important information about the installation and use of this light product.
Please strictly follow these related instructions during installation and use.
The lamp cast aluminum shell of this product is combined with each other, beautiful in
appearance, smooth and strong, which fully reflects the characteristics of modern lighting
products. The products are designed and produced according to strict standards and fully
comply with the international standard DMX512 protocol. They can be controlled by a
single unit or linked to each other. They are suitable for large-scale theatrical
performances, theaters, studios, auditoriums, temples, churches and other places.
Benchengjie lamps use high-precision accessories. When you receive the product, please
take care of it and check whether the product may be damaged due to transportation. And
check the following accessories:
1. Lamps-1 set 2. Power cord-1
3. Signal line --- 1 piece 4. Manual --- 1 copy
首先感谢你选择了本公司的产品，请仔细完整地阅读这份使用说明手册，并妥善保管，以便
使用时参考。本使用说明书中包含有关本灯产品的安装及使用方面的重要信息。安装及使用
时请严格遵守这些相关的说明。
此产品灯铸铝外壳相互组合而成，造型美观，流畅，结实，充分体现了现代灯具产品的特点。
产品按严格标准进行设计生产，完全符合国际标准 DMX512 协议，既可单台控制，也可以
互相联控使用，适用于大型文艺演出、剧院、演播厅、礼堂、寺院、教堂等场所使用。
本成介灯采用高精密配件。在收到产品时，请小心取放，检查产品是否有因运输而可能造成
的损坏。并检查以下配件：
1.灯具----1 台 2.电源线---- 1 根
3.信号线--- 1 根 4.说明书---1 份
This product is an LED two-eye audience light
If the product has gone through a large temperature difference (for example, after
transportation), do not start the product immediately
The product will be damaged due to thermal expansion and contraction. Please wait until
the device reaches normal room temperature before starting the product.
Pay attention to shocks. Avoid strong collisions during product installation.
When choosing an installation location, make sure that the product is not exposed to
excessive heat, humidity or dust. Please do not put any wires on the ground, otherwise
there may be danger of electric shock.
Before installing the product, make sure that the installation point is safe.
Please fasten the product with a safety rope and check whether all the screws are correct
when installing
Make sure that the lens is in good condition. When the lens is damaged or scratched,
please replace the lens.
It is recommended that technicians familiar with this product operate this product.
To Next Page
Loading...
