Chapter 1 Welcome to Use It
1.1 About the Product
Welcome to use the TK205 watch GPS Tracker. This exquisite watch is designed for the
elderly/children positioning and guarding, businessmen safety precautions and field personnel
management. At the same time, it is available with GPS/GPRS function and GSM/SMS/GPRS
communication with a quick signal receiving speed.
1.2 Safety Considerations
To ensure your safety, please read the following Safety Considerations carefully：
1.2.1 Storage Considerations
¾ Don’t put this product directly in the sun or in a dusty place or pile it with other electronic
products for fear of damage. Keep it off the equipments with strong electromagnetic radiation
or a strong magnetic field as far as possible.
¾ Don’t put its batteries, terminal or charger in a microwave oven or a high-pressure device for
fear of such accidents as circuit damage or fire.
¾ Don’t put the terminal on an uneven or unsteady table for fear of malfunction or damage if it
drops on the ground.
¾ Keep the product off dampness and water.
1.2.2 Batteries Operating Instructions
¾ When the product is first used, please use up the battery power and charge the battery for 2-3
times for not less than 12 hours each time, so as to ensure the battery in good condition.
¾ Please charge the battery with the charger provided by our company. All damages due to the
use of any other charger are on the user’ s account.
¾ Don’t drop the batteries in fire for fear of burning or explosion of the batteries.
¾ Don’t put any stress on the batteries during battery installation, or the batteries will be subject
to leakage, overheat, cracking or burning.
¾ Don’t dismantle or refit the batteries for fear of leakage, overheat, cracking or burning.
¾ Don’t use or store batteries in a hot place, such as by the fire or a heater, for fear of leakage,
overheat, cracking or burning.
¾ In case of such abnormalities as discoloration and a rise in temperature when the battery is
used, charged or stored, please stop use and replace it.
¾ Keep the batteries of dampness for fear of overheat, smoking or corrosion.
1.2.3 Whole System Operating Instructions
¾ Don’t dismantle or refit the machine on your own. Our company is not responsible for any
damage due to any illegal operation.
¾ Don’t use the terminal near an electronic device with weak signals or high precision, or the
radio wave interference might cause wrong operation on the electronic device or other
problems。
¾ Don’t put the terminal too close to such magnetic objects as a magnetic card, or the radiation
To Next Page
Loading...